Dołączył(a): środa, 31 maja 2006, 01:26 Posty: 3400 Lokalizacja: pl_PL.lodz
DESCRIPTION The recoverdisk utility reads data from the source file until all blocks could be successfully read. If destination was specified all data is being written to that file. It starts reading in multiples of the sector size. Whenever a block fails, it is put to the end of the working queue and will be read again, possibly with a smaller read size.
By default it uses block sizes of roughly 1 MB, 32kB, and the native sec- tor size (usually 512 bytes). These figures are adjusted slightly, for devices whose sectorsize is not a power of 2, e.g., audio CDs with a sec- tor size of 2352 bytes.